Run Every Fixture on One Schedule, Without the Heat SpikesThe Maxibright DAYLIGHT Lighting Controller gives growers a single command point for compatible Maxibright LED and CMH fixtures, replacing the guesswork of setting each light and timer by hand. It manages two independent zones (A & B) with a built-in 24-hour timer, sunrise and sunset ramping and temperature safety dimming, so a whole grow room or grow tent stays on one stable, repeatable light cycle.Key Benefits Two independent zones (A & B) so veg and flower rooms, or two tents, run on separate schedules from one unit Scales to 400 HID ballasts or 100 LED drivers (200 HID / 50 LED per zone) for small setups through to commercial rooms Sunrise and sunset simulation ramps lights up and down gradually to cut transplant and photoperiod stress Temperature safety dimming automatically pulls output back if the room overheats, protecting plants during flower Precise 1% dimming steps (LED 20-100%, HID 50-100%) for exact control of intensity and canopy temperature iLink daisy-chain connectivity links compatible fixtures together with minimal wiring Beating Heat Stress and Out-of-Sync LightsRunning several fixtures on separate plug-in timers leads to drifting light cycles, uneven intensity and heat stress that stalls plants at the worst possible moment in bloom. The DAYLIGHT Controller synchronises every connected light to the same programme, and its temperature safety dimming steps output down before heat damages the canopy, while sunrise/sunset ramping keeps transitions gentle for stronger roots and steadier growth.How to Use Mount the controller in a dry, accessible spot in the grow room. Connect compatible LED or CMH fixtures to the iLink ports, daisy-chaining additional lights with iLink cables as needed. Assign each fixture to Zone A or Zone B to match your room layout. Set the 24-hour schedule for the current growth stage (typically 18/6 veg, 12/12 flower). Dial in dimming levels and enable sunrise/sunset ramping. Leave temperature safety dimming active so the controller can protect the canopy from heat. Technical Specifications Control zones: 2 independent (A & B) Maximum HID ballasts: 400 total (200 per zone) Maximum LED drivers: 100 total (50 per zone) LED dimming range: 20-100% in 1% increments HID dimming range: 50-100% in 1% increments Timer: integrated 24-hour Protection: temperature safety dimming Connectivity: iLink ports for fixture daisy-chaining Compatible fixtures: Maxibright Daylight 660W LED, 480W LED, 315W HID (CMH)
