Zvizzer MC 3000 - Correct and Finish in One Step MC 3000 is Zvizzer's medium cut one-step compound, the polish that corrects and finishes in a single stage. It clears P3000 sanding marks, fine scratches and swirls, then refines the paint to a hologram-free gloss in the same pass, with no separate finishing step. For light to medium correction, that turns a two-stage job into one. A self-grinding, homogeneous abrasive makes it work: it cuts to lift the defects, then breaks down as you polish to leave a smooth, uniform finish. The water-based, silicone-free formula stays low on dust and wipes off cleanly. Use it across all standard paint systems, including scratch-resistant clear coats, whether the paint is fresh or fully cured. Corrected, finished and ready to protect - in a single step. Application MC 3000 works with both rotary and orbital machines. Start with a clean pad and prime it before your first pass. Apply a small amount of compound to the pad or the panel and spread to cover your working area. On a rotary, spread at around 650 rpm, then increase to roughly 1,400 rpm under moderate pressure to cut and refine, working back down the speed range to jewel. On an orbital, spread on speed 1 and work up to speed 5. Either way, work one section at a time. Across a full correction, keep two or three pads on the go and swap them between sections. Letting each pad cool holds the cut consistent and protects your finish. Available in 250ml and 750ml. Pairs with: Orange Thermo Allrounder Pad - the colour-matched medium polishing pad for MC 3000 Thermo Hybrid Pad - extra cut for one-step work on firmer paints Graphene Spray Coat - seal the finish with a fast, hydrophobic top layer Zvizzer Microfibre Cloths - colour-coded, lint-free cloths for a clean wipe-off and no cross contamination
