Hard Anodized Black MDC (Malkoff Daily Carry) 300 Lumen, Tactical 1CR123 Flashlight. This is a tailcap switch activated multimode light. Modes are High-Med-Low. It always comes on in High. The light has a Black Type III Hard Anodized finish. They are fully potted and use the same reflector as the M61 for a good balance of throw and spill. The LED is a White (5700K) Luminous SST-20. This light will support standard CR123 primary lithium batteries. It will NOT SUPPORT rechargeable Li-ion batteries. Mode of Operation: The switch debounce time is 150 milliseconds. The mode will advance each time the light is momentarily activated and the switch debounce time has passed. This light USES ON TIME to determine mode switching. If the light is left ON for more than 1 second, the NEXT off/on cycle will return the light to High. If the light is NOT LEFT ON for 1+ seconds the NEXT off/on cycle will advance the mode. The off time has no relation to the mode switching of the light. In most normal use, the light will always come on in High. Summary of Modes: 300/50/3 Lumens Approximate Runtime in modes: 1/20/100 Hours The optional Titanium Deep Carry MDC Pocket Clips are custom designed and manufactured by LynchNW exclusively for the Malkoff Devices line of MDC Pocket Lights. They are made of Grade 5 6AL-4V Titanium with a Stone Washed Finish. These pocket clips prevent the user from standing the flashlight on its tail. Product Page Dimensions: Length: 3.75 inches Diameter: 1 inch (head) This Flashlight was designed for rugged service from the ground up. It is fully potted to stand up to rough service and recoil. This Item is Covered by Our Lifetime Warranty. STAINLESS-STEEL BEZEL OPTION The stainless-steel(SS) bezels fit this head and any MDC head that uses a reflector. If purchased from this screen, the stainless-steel bezel will be installed on the head. The original black-anodized aluminum bezel will be included. Standard MDC SS Bezel sold HERE. Crenelated MDC SS Bezel sold HERE. Things to Know Before Purchase: This flashlight was designed for use with a single primary lithium CR123 Battery. DO NOT USE A RECHARGEABLE Li-ion CELL. The voltage is too high. The input voltage is 2 - 3.2 volts for full output. Input voltages of more than 3.3 volts may damage this flashlight. This light is protected against reverse polarity. WARNING: This light is capable of causing eye damage at close range. Please use the light responsibly!!! Made in the USA. Some parts not domestically sourced.
