milKit makes tubeless conversion a breeze! This is your one stop shop for converting your mountain bike or road bike to tubeless tires. Running a tubeless set up has many advantages: it is lighter, more resistant to pinch flats, has better traction and avoids ride stopping punctures from thorns and sharp stones. However, before milKit revolutionized tubeless mounting, getting your wheels set up was a long messy job. Checking sealant levels was equally tiresome, so many riders ran the risk of riding without sealant as checks meant more mess! milKit has made this easy: Install rim tape Install milKit valves and screw out the milKit valve core Pre-inflate your tire up to 22 psi (we recommend the milKit Booster) – the rubber valve flaps ensure no air is lost even without the valve core installed Measure out the correct amount of sealant and insert into pressurized tire using the syringe: mess-free! Screw the valve core back in and inflate the tire to full riding pressure – the tire now jumps onto the rim fully. You’re ready to ride! Ongoing maintenance is also easy. With other tubeless tire systems you need to remove the tire to check if enough sealant remains, with milKit you can simply remove the valve core and insert the syringe to check. No mess and faster results! The syringe holds 60ml or 2 oz of fluid and comes with a flexible connector and a large needle to push through the valve and rubber flaps. There’s also a sealant regulator that screws into the syringe for easy refilling. The needle has an angled end for effective removal of all sealant in the tire so you know exactly how much sealant is in there. Rubber flaps at the bottom of the valve prevent sealant from filling and blocking the valve, as well as ensuring no air is lost when the core is removed. milKit sealant is thicker than others and always stays a consistent homogenous liquid. There is no need to shake it before use. In the tire, the milKit sealant does not decompose into rubber particles and an aqueous residue, but it dries evenly and slowly and therefore remains effective longer than comparable products. milKit sealant’s microfibers give it a strong puncture sealing capability, with results for tears of up to 6mm. It covers the inside of the tire evenly, and adheres better to the tire wall than thin latex products, so the all-important microfibers are distributed optimally and ready to act as soon as you puncture. The conversion kit contains everything you need to convert to tubeless: milKit valves with rubber flaps that ensure clean and easy setup and maintenance milKit compact syringe to measure and refill sealant through the milKit valves milKit tubeless sealant that stays effective longer and repairs bigger tears Rim tape needed to convert your wheels to tubeless 1x milKit sealant bottle 250 ml / 8 oz 1x milKit compact syringe system 2x 45 mm milKit tubeless valves 1x 10m/11yd roll of milKit tubeless rim tape 21, 25, 29, 32 or 35mm/0.82in 1x additional needle for syringe filling 1x valve core tool
