A clear, oil-based, durable protective finish providing long lasting protection and beauty to any interior wood surface. Features Provides long-lasting beauty and protection to any interior wood surface Among the most durable coatings for wood protection Ideal for woodwork, furniture, doors, cabinets and floors Can be used on both finished and unfinished wood USE Interior wood surfaces including furniture, cabinets, doors, and floors COVERAGE Half Pint (236 millilitres)- One Coat of approximately 50 square feet of surface space Quart (946 millilitres)- One coat of approximately 150 square feet of surface space Gallon (3.79 litres)- One coat of approximately 400-600 square feet of surface space *Coverage may vary depending on the surface porosity and texture* SURFACE PREP Surface must be dry and free of old finishes in poor condition, paint, wax, grease, polish, dirt, or other foreign matter Sand to obtain a smooth uniform finish Remove all dust with a cloth dampened with mineral spirits APPLICATION Use in a well-ventilated area Always spot test on an inconspicuous area to ensure satisfactory results Stir thoroughly before and during use to eliminate settling on the bottom of the can Stir in such a manner as to rotate the product from the bottom to the top of the can. NEVER SHAKE Apply a thin coat. Let dry for 4-6 hours; then lightly sand entire surface with fine sandpaper (220 grit) to ensure an even finish and proper adhesion; remove all dust; apply a second coat If a third coat is desired, repeat above step before application of third coat 3 coats is recommended Product can be applied using a high-quality natural or foam brush Always test tackiness between coats; do not sand or re-coat when surface is tacky When used on wooden floors, use a lamb’s wool or synthetic pad applicator or natural bristle brush and maintain a wet edge to avoid lap marks Slight ambering may be experienced when polyurethane is applied over light-coloured wood surfaces Keep container closed when not in use Keep out of reach of children It is recommended that anyone who is applying the product or present during application of this product, especially those who are asthmatic, follow the manufacturer's safety precautions It is recommended that pregnant women are not present when product is being applied and drying DRYING Allow 4-6 hours between coats After final coat, allow 24 hours before light use Avoid heavy traffic and replacing furniture for 72 hours after final coat; do not slide furniture Do not install rugs or clean floors for 7 days after final coat Dry times are based on good ventilation, temperature of 25°C (77°F and 50% relative humidity Lower temperatures, higher humidity, lack of air movement, or application of thick coats will extend drying times CLEAN UP & STORAGE For easy clean-up use mineral spirits or paint thinner In case of spillage, absorb with inert material and dispose of in accordance with local regulations Wash thoroughly after handling When storing, tightly close container and store upside down Store in a well-ventilated area Do not store near heat, sparks, open flame, or other sources of ignition Protect from freezing Use completely or dispose of properly SAFETY & TECHNICAL DATA SHEETS Safety Data Sheet-Satin (Half Pint) Safety Data Sheet-Semi-Gloss (Half Pint) Safety Data Sheet-Gloss (Half Pint) Safety Data Sheet-Satin (Quart) Safety Data Sheet-Semi-Gloss (Quart) Safety Data Sheet-Gloss (Quart) Technical Data Sheet (Fast-Drying Polyurethane Varnish)
