Motion Raceworks Parachute Essentials. These are the 3 things every parachute systems needs. Motion Raceworks Parachute Cable Holder 14-00007 Motion Raceworks parachute cable holder clamps the parachute cable to the side of the parachute pack. This is used to make sure the entire cable does not try to move in applications where the cable is not secured in close proximity to the parachute pack itself. Using two mounting holes, if you have a Motion Raceworks Parachute Mount you can use the existing two holes in our "x plate" where the pack is mounted you can mount on either side of the pack. Can also mount this on non Motion Raceworks Parachute kits by simply drilling two separate holes. Included: -Main bracket (anodized black) -Billet clamp (anodized black) -All necessary hardware (5 5/8ths center to center bolt hole spacing) Learn about how the cable holder works in this video and why it is necessary! Parachute Cable Billet End Cap 14-00009 Frayed parachute cable ends can and do often times cause false deployments. The inner loop snags on the inner braided wires. This piece has inner threads, so simply screw it on to your .320" outer diameter cable and the threads will dig into the plastic outer material. Stroud Remove Before Flight Safety Tag/Pin This red "Remove Before Flight Tag" is a nice pin to put in your chute when traveling to prevent accidental deployment in the trailer or when moving your race car around. **NOTE** This video is a bit older, and the pricing is incorrect Installing a parachute cable handle? Watch this video to make sure you are ready to go to the track after install!
