Motolab Tempest Flight Controller With Integrated PDB V1.2Designed with the fpv racer in mind, the Motolab Tempest provides the heart of your mini quad with everything it needs to win. A F3 flight controller, along with a built in PDB can help simplify as well as clean up your builds tremendously. This high quality product should be on every fpv pilot's list. The Tempest uses the same STM32F3 CPU with ARM-Cortex M4 core and floating-point coprocessor for more efficient execution of fast-looptime control algorithms, along with the low-noise MPU-6000 SPI-bus gyro chip for faster acquisition of gyro data. This board is compatible with Cleanflight and Betaflight firmware, using the MOTOLAB target files. The PWM outputs are bidirectional, and the board is compatible with BLHeli ESC passthrough programming through the USB port using BLHeliSuite. Specifications: A single connection for the lipo to power both the flight controller and ESCs. An on-board 1.5A 5V current-limited switching regulator for direct connection to lipos up to 4S, or up to 6S with power filtering. A 1A rated LC-filtered power output for VTX/camera. USB interface independent of UART channels. Three hardware UARTs. Reverse current protection on lipo and USB inputs for problem-free ESC calibration. Dedicated serial LED/transponder output with regulated 5V and GND. On-board buzzer driver with 5V and lipo voltage option. Built-in VBAT monitor with low-pass filter from lipo input. Dedicated SAT receiver interface with 3.3v using JST connector for compatibility with Spektrum/LemonRC cables. Dedicated PPM and serial receiver interfaces with 5V power using 0.1" headers. Compatibility with receivers using Spektrum 1024/2048, SBUS, SumD and SumH receivers with built-in inverter. High-quality gold plated multilayer printed circuit board. Connector location on the board edges for convenient access to serial interfaces and other peripherals. PWM outputs on the corners near the motors. Plated holes for all connections, with the exception of USB and UART 1 on quick-connect JST-SH. Assembly note: For the cleanest build, run wiring under the board where possible. Cut and strip wires to the appropriate length, twist and pre-tin the wire ends with solder, and insert the wires into the bottom side of the PCB. Solder from the top side. Pin-out has changed from V1.1 to V1.2 - Please take note Includes:1x Motolab Tempest Flight Controller With Integrated PDB V1.2
