3MSK-ESDC-3000 is separable 80 mm Dia. x 200 mm L stainless steel drum collector (MSK-DC-3000) and 6-hole oscillation fixture control console (MSK-MD-300) for the nano-fiber electro-spinning DIY system. In this setup, the nano-fibers are winded in the form of an aligned nonwoven membrane on a rotating drum. This method provides a relatively high production rate compared to the plate collector method. The collector and fixture are adjustable freely, and they can be purchased separately. Selection is available at the top right selection bar, for more information, please contact us. If you use High voltage power in the system, must do Grounding tests (GFCI) before first-time use. Improper grounding may damage the unit. SPECIFICATIONS Model (MSK-ESDC-3000) and Features (Combination) The combination of MSK-DC-3000 and MSK-MD-300, which is separable. DIY electrospinning system with drum collector and oscillation fixture Manually adjusting space between the drum collector and oscillation fixture 24VDC motor an Ar gas environment compatible Note: MSK-ESDC-3000 can be purchased in one full set, or separately. For more information, please contact us. To built the DIY high voltage electrospinning process, there is more equipment that might need to built-in with. The example is shown below: Model Drum Collector (MSK-DC-3000) Oscillation Fixture (MSK-MD-300) Features Drum collector with adjustable rotation speed and digital speed display The compact, modular design enables DIY flexibility Rotation speed: 100 - 4500 rpm adjustable Speed accuracy: +/- 5 % rpm Drum size: 80 mm Dia. x 200 mm L Syringe needle holder to mount up to 6 needles (6 slots of 12 mm Dia. ) Oscillation speed is adjustable. The needle head suggested having 100-200mm distance with collector drum Fixture movement distance: 50 – 270 mm Input Power 110 ~ 240 VAC 50/60 Hz, 50 W 24VDC power input 110 ~ 240 VAC 50/60 Hz, 50 W 24VDC power input Dimension Size Controller box: 125mm L x 210mm W x 105mm H Collector part: 430mm L x 160mm W x 150mm H Controller box: 120 L x 200 W x 85H (mm) Fixture Part: 400L x 120 W x 370 H (mm) Optional (Not Included) To build a DIY electrospinning system, you may need A high voltage power supply A syringe pump controller to deliver polymer solution A fume hood to enclose the system for safety and health 1 2 3 Warranty One-year limited warranty with lifetime support. Shipping Weight 40 lbs Application Notes The ability to generate aligned fibers and the degree of alignment depending on the polymer-solvent combination, viscosity, applied voltage, tip-collector distance, and drum rotation speed. User shall do an experiment for best results Use a properly grounded electrical outlet and away from sources of electromagnetic interference. Improper grounding may cause charge build-up and damage the unit The electrospinning process uses HIGH VOLTAGE! Stay clear of the syringe needle or drum collector during the process to avoid electric shock! Beware of short circuit damage to the unit due to leaking or a short distance between charged syringe needle and drum collector Solvents and chemicals used for electrospinning may be poisonous, flammable, oxidizing, or corrosive. It is the user’s responsibility to understand the risks associated with the process and use proper protection. The user is advised to wear protective clothing, mask, goggles, and gloves. The electrospinning process should be confined in an enclosed chamber, such as a fume hood, with proper exhaust handling capability
