PIONEER (ND-BC8) NTSC UNIVERSAL CAMERA, MIRROR-IMAGE - REARVIEW CAMERA WHILE YOU'RE AT IT There's no better time to install a backup camera in your vehicle than when you're already installing a new DVD or navigation receiver. Take advantage of your in-dash video capabilities by gaining a wide-angle view of what's behind you every time you shift into reverse. The Pioneer ND-BC8 backup cam enhances your rear view by counteracting harsh overexposure on bright days as well as giving you a sharp picture in low light. INSTALLING THIS CAMERA YOURSELF? HERE'S WHAT YOU SHOULD KNOW. What does it do? Unless otherwise noted, a backup camera is only intended for use backing up your vehicle. (If you require a front-view or constant rear-view camera, check for that capability.) What tools and supplies will I need? A panel tool, a wire cutter/stripper, a soldering iron, and a rosin-core solder with heat shrink tubing are recommended, along with whatever tools are needed to remove the radio from the dash. How much wiring is required? Wiring instructions vary from camera to camera. Some cameras have power wiring that can only be connected near the radio. Others let you power the camera at compatible reverse lights. In all cases, the camera must be wired for power and ground, the camera's video output must be connected to the radio/monitor, and the radio/monitor must be connected to a reverse trigger in your vehicle. Some radio replacement interfaces supply a reverse trigger wire for the radio -- using that wire to power your camera will damage the interface. Will the included video cable be long enough? You'll need to route the camera's video cable from its mounting location outside your vehicle into your vehicle's cabin and all the way to the screen in the dash. This often requires drilling a small hole in your vehicle or filing some metal and or plastic. You'll also need to estimate the length of cable needed to run from the camera to the dash, which will not be a straight shot. Each camera's cable length is listed. Note: A rear-view camera provides an additional view when reversing your vehicle. It is intended to be used in conjunction with your rear- and side-view mirrors to give a fuller picture of what's behind you. It is not intended as a replacement for your mirrors. FEATURES: Backup camera with standard composite video cable Compatible with any radio with an RCA video input (most aftermarket models, only a few factory) 1/4" CMOS image sensor with approximately 310,000 pixel resolution Color video output 129-Degree horizontal and 105-degree vertical viewing angles 0.9 Lux minimum for night driving Weather-proof camera housing Universal mounting hardware and 30-foot power/video cable included Camera dimensions: 15/16"W x 15/16"H x 1"D
