Nerta Snowfoam is a concentrated pH-neutral nano-active snow foam pre-wash that produces a thick, creamy clinging foam to safely lift dirt, dust and road film off bodywork before the contact wash — designed to be safe on wax, sealant and ceramic coatings. The pH-neutral formula (pH ~7.5) with a refreshing coconut scent makes it the go-to pre-wash for detailers protecting investment paintwork on cars, vans, motorhomes and detailed show vehicles. Long dwell time and dirt-repellent action mean less contact and fewer wash-induced swirl marks. This is a concentrated formula and must be diluted before use. Why detailers choose Nerta Snowfoam pH-neutral formula — safe on wax, sealant and ceramic coatings Thick, creamy snow foam with extended dwell on bodywork Nano-active dirt-repellent technology lifts contamination without scrubbing Pleasant coconut fragrance for a more enjoyable wash bay Compatible with foam lance, foam system and pressure washer Concentrated for low cost-per-vehicle on regular use How to use Nerta Snowfoam Pre-rinse the vehicle to clear loose dirt and dust. Dilute Nerta Snowfoam at the recommended ratio for your foam lance (typically 1:10 to 1:20). Apply via foam lance or foam system from the bottom upwards for full coverage. Allow 3–5 minutes dwell time — do not let the foam dry on the surface. Rinse off thoroughly with clean water from the top down before contact washing. Specifications Type: pH-neutral concentrated nano-active snow foam pre-wash Sizes: 5L, 20L, 200L (see variants) Dilution: 1:10 to 1:20 in foam lance pH: ~7.5 (neutral) Scent: coconut Foam density: thick and creamy Use on: paint, glass, plastic trim, ceramic-coated and waxed surfaces FAQs Is it truly safe on a freshly applied ceramic coating?Yes — at pH ~7.5 it is fully ceramic-coating safe. Wait at least 7 days after a fresh coating before first use, then it can be used as the standard weekly pre-wash. How does “nano-active” differ from a standard snow foam?The nano-active surfactants encapsulate dirt particles at a microscopic level so they release from paint without you having to scrub — measurably reducing wash-induced micro-marring. Why is the foam thick rather than runny?Thick foam clings vertically to panels for several minutes, which is essential for letting the chemistry break down dirt before the rinse. Runny foam slides off before it can do its job. Can it be used in a roll-over arch system or only with a hand foam-lance?It is optimised for foam lance and foam system pre-wash. Roll-over arches typically use lower-viscosity arch-specific foams — check with your equipment manufacturer first. UK stock and fast dispatch from SnowFoam UK on every order.
