Nikwax TX Direct Spray On - 500ML The high performance water proofer designed to enhance performance and revitalise the breathability of waterproof clothing with wicking liners. Easy to apply by hand, non flammable, PFC and aerosol free. Spray on Water proofer for wet weather clothing, adds water repellency and revives breathability. A 500ml Bottle will waterproof approx. 2-3 garments depending on their condition For waterproofing rain gear Easy to use spray-on waterproofing for all breathable waterproof clothing with wicking liners Adds water repellency to the areas that need it most and revives breathability without tumble drying Enhances the performance of your gear, keeping you warmer and drier Recommended for Gore-Tex®, Sympatex®, eVent®, Nikwax Analogy® and all other waterproof fabrics Breathable waterproof garments are most likely to get sweaty and wet inside when used in damp or wet conditions. If the outer fabric absorbs water, the garment can lose up to 70% of its breathability. Therefore, the Durable Water Repellency (DWR) on the outer fabric of your jacket must be maintained to ensure comfort. It will eventually wear off and need to be renewed with Nikwax TX.Direct®. Waterproof clothing needs to be breathable… When we work hard, we sweat. The evaporation of sweat cools us down and keeps us comfortable. But, when it rains we want to avoid getting wet, so we put on waterproof outerwear to keep us dry. The waterproof fabric must allow moisture vapour to pass through it, or 'breathe'; otherwise our sweat cannot evaporate, causing us to overheat and get wet from condensation. Additionally, if the outer fabric of your garment absorbs water and ‘wets out’ its breathability will be reduced, causing you to feel clammy and wet. How to use: Apply Nikwax TX.Direct® Spray-On by hand… For best results remove all non-washable parts and always clean item(s) first with Nikwax Tech Wash®. No need to dry item(s) before waterproofing. Shake well before use. Follow care label instructions. Protect working surface and lay clean wet fastened garment flat. Hold bottle 15 cm/6 inches away from garment. Apply evenly to outside of fabric. Wait for 2 minutes. Remove any surplus product with a damp cloth. Check carefully to ensure no areas have been missed. Volume Guide: These volumes are approximate and depend on the condition of the fabric being treated. Jacket 250ml; Over suit 400ml; Over trousers 150ml; Gaiters 70ml Nikwax TX.Direct® treated clothing needs no heat to develop Durable Water Repellency (DWR)… Air dry (after several minutes check for and remove surplus product with a damp cloth) or tumble dry on a low setting if care label allows.
