ONE PAIR of Double Sided LED Bar End Turn Signals, for 7/8" handlebars. Bar end motorcycle indicators by Oberon Performance. Bi-directional LED CAD/CAM designed to increase safety and to alleviate most of the current LED aftermarket indicators issues. Benefits include: Improved motorcycle safety Highly visible Extra wide angle viewing pattern LED flash visible from front and rear of indicator body (double sided) Instant illumination and no fade Small current draw Billet aluminum housing 12 Volt LEDs High power amber LEDs Elegant design Stainless steel fasteners Collets to suit 12mm to 19mm handlebar internal diameters (7/8" bars). Indicator body size: 50mm long x 35mm diameter Weight (Each): 100g The indicator uses eight high powered wide angled LEDs either each side of the circuit board. Each indicator is visible from both the front and the back of the unit with equal luminosity. This has a substantial improvement on the visibility of the indicators and being at the very end of the handlebar, greatly adds to the safety of the motorcycle and rider. Due to their low draw rate and very nature, LEDs offer a much longer life than ordinary filament indicator bulbs. LEDs do not have a time delay on operation so they are instantly on at full power and off with no fade. Again this gives a distinct and noticeable flash or presence to other road users making it much less likely for the indicator to be ignored or overlooked. One of the most common complaints we have observed at Oberon Performance, is of the many other motorcycle indicators that have low quality lenses. Our unique lens fully envelopes the LED circuit board completely with a 360 degree solid wall providing a melt proof, shake proof and loss proof cover. These indicators are CNC machined from billet aluminum and are available in black or silver anodize. Complete with stainless steel fasteners, sleeved cable (350mm long) and a brass collet to allow fitting to hollow handlebars for most motorcycles. Fits a range of 7/8" handlebars using included collets. ***NOTE: - Some motorcycles are fitted with Bulb type Indicators, EVEN some modern bikes. You may need Resistors (available here) to control the flash rate. - Due to the high power and heat that is produced by these LEDs they need to remain cool during operation, please do not wire them to be permanently on as running lights, or fitted in conjunction with heated grips for example. PDF Diagram for LED Indicators
