Fast, satisfying correction in a single step The One-Step Paint Correction Kit is the easiest way to erase light–moderate swirls and boost deep gloss on daily drivers. Pair Perfect Polish with our SmartCell™ foam to correct and finish in one pass on many paints—then swap to the black pad to jewel that last bit of clarity. What’s inside Perfect Polish (16 oz) – low dust, long work time, wipes clean. 2 × Orange Polishing Pad – 5" (ETH-OPP-5) – primary one-step cut/finish. 1 × Black Finishing Pad – 5" (ETH-BFP-5) – final gloss/jeweling. 2 × Plush 470 Towels – Gray – soft, edgeless wipe-off. Why you’ll love it One-step capable on many paints—real correction with a glossy finish. DA-friendly (5" backing plate) with stable pad control. Low dust & easy wipe-off to keep the job moving. How to use Decon wash & clay. Tape sensitive trim. Prime the orange pad, add 3–4 pea-size drops of Perfect Polish. Work 2'×2' sections at speed 4–5 with moderate pressure for 2–3 section passes. Reduce pressure for a slow, final pass. Wipe clean with a Plush 470 towel. Optional: Swap to the black pad with a small amount of polish to jewel. Panel-wipe if applying protection; seal with Resist or your coating. Good to know For deeper defects or heavy oxidation, step up to our Two-Step Correction Kit. Not for matte/satin paint or PPF. Always test a small area first. Clean pads frequently for consistent results. What it fixes Light–moderate swirls, washing marring, light haze, and reduced clarity. Kit Correction (Cut) Finish Gloss Best For Primary Pads Liquids Typical Steps ETH-KIT-1STEP-5 Medium (foam) High Daily drivers, light–moderate swirls Orange + Black foam Perfect Polish 1 step (optional jewel) ETH-KIT-2STEP-5 High → Max Maximum Full restorations, moderate–heavy defects MF + Orange + Black Pure Cut + Perfect Polish 2 steps ETH-KIT-1STEP-MF-PC-5 High (one-step) Med–High (quick jewel on soft paint) Harder/neglected paint with limited time One-Step MF + Black Pure Cut 1 step (optional quick finish) ETH-KIT-CPD-5 Maximum Medium (refined) Severe swirls/oxidation, RIDS MF Cutting + Orange Pure Cut 1–1.5 steps (finish recommended) ETH-KIT-FIN-5 Low Maximum Pre-coating jeweling, light haze removal Black + Orange foam Perfect Polish 1 finishing step
