Protect what matters! MOJAB ORI Strut Protective Jackets are designed to shield the exposed stainless piston from rocks, debris, mud, and trail abuse. One bad hit can turn into a very expensive ORI service — this jacket helps prevent that. ✅ Easy install with full-length Velcro closure (no tools) ✅ Washable & reusable ✅Designed to protect the exposed shaft at normal ride height and during transport/trailering. ✅ Works with all ORI strut lengths (total Jacket length 19.7”) Built for hard wheeling, dust, mud, and rocks. Less damage. Less downtime. More confidence on the trail. ✅ Designed specifically for ORI struts ✅ Helps prevent nicks, dents, and contamination ✅ Sold as a pair Because protecting your suspension is cheaper than rebuilding it. Installation Tips: To get the best performance and longevity out of your ORI Strut Jacket, please follow these installation guidelines: • Start from the bottomBegin installation just above the lower fitting/valve area of the strut to protect the exposed shaft at normal ride height • Leave slight slack at the bottomLeave approximately 2–3 inches of slack at the bottom to allow for natural suspension cycle. • Secure the top tightlyUse the provided zip tie at the top to lock the jacket firmly in the ORI’s Grove This prevents any movement or sliding during suspension travel. • Ensure full closureMake sure the Velcro is fully sealed along the entire length for maximum protection against debris. Note: this product is considered a consumable item! Depending on usage and conditions, it may last a full season—or require replacement sooner. Regular inspection is recommended, and replacement should be expected as part of normal use. FAQ: 1)What is the ORI Protection Jacket designed for? The ORI Protection Jacket is designed to help protect the exposed shaft of your ORI strut from small rocks, gravel, and trail debris kicked up by large off-road tires while driving. It acts as a sacrificial protective layer against common debris impact during low-speed and high-speed off-road use. 2)Will this protect my ORI from large rocks or direct trail impacts? No. This jacket is not designed to protect against large rocks, hard direct hits, or major impacts from obstacles. It is made from neoprene and is intended mainly to reduce damage from small debris and gravel being thrown toward the strut while the vehicle is moving. 3)What ORI lengths does this jacket fit? The ORI Protection Jacket is adjustable and is designed to fit ORI struts from 12” to 20” travel. 4)Is the ORI Protection Jacket washable? Yes. You can clean it with a hose or pressure washer. After washing, we recommend opening the bottom of the jacket and allowing it to fully dry so moisture does not stay trapped inside. 5)Does this product have a lifetime warranty? No. The ORI Protection Jacket is a wear item. It is designed to take abuse and protect the ORI shaft, so over time it may need to be replaced depending on use, conditions, and trail 6)Can dirt, sand, or moisture get inside the jacket? Yes, like any protective cover used in off-road conditions, dirt, sand, or moisture can get inside over time. We recommend checking and cleaning the jacket regularly, especially after muddy or wet trail runs, and letting it dry fully before reinstalling or closing it back up.
