Zvizzer PC 5000 - Maximum Cut for the Deepest Damage PC 5000 is Zvizzer's pre cut compound, the most aggressive cut in the detailing line before sanding, and the place heavy correction begins. Built with a high abrasive load and coarse particle size, it eats through deep scratches, severe defects and P1500 sanding marks that finer compounds would take all day and several passes to touch. When paint is badly weathered, oxidised or scarred, this is your opening stage - you WILL need refinement though. A blended aluminium oxide abrasive gives PC 5000 its raw cutting speed, resetting the surface so the rest of your correction has a clean canvas to work on. It is a dedicated pre-polish step rather than a finishing polish, so always follow it with a cutting and finishing stage to bring the gloss back up. The water-based, silicone-free formula suits all paintwork, including scratch-resistant clear coats, whether fresh or fully cured. The heavy lifting done first, so every stage after it is uniform and easy. Application PC 5000 works with both rotary and orbital machines, though we would recommend orbital. Start with a clean pad and prime it before your first pass. Apply a small amount of compound to the pad or the panel and spread to cover your working area. On a rotary, spread at around 650 rpm, then lift to roughly 1,400 rpm under moderate pressure to cut. On an orbital, spread on speed 1 and work up to speed 5. Either way, work one section at a time. Because this is your heaviest cutting stage, keep two or three pads on the go and swap them between sections. Letting each pad cool holds the cut consistent and protects your finish. Available in 250ml and 750ml. Works well with Blue Thermo Allrounder Pad - the colour-matched cutting pad; grab a few to keep in rotation Thermo Nano Wool Pad - maximum bite for the most severe defects Zvizzer HC 4000 Heavy Cut - your next stage to refine the cut and build gloss Zvizzer Microfibre Cloths - colour-coded, lint-free cloths for a clean wipe-off and no cross contamination.
