120W RMS Two Channel Power Amplifier with Dante Features Stereo into 4-8 Ohm loads Bridgeable for 70V or 1 00V (Direct Drive) Slot card with integrated Dante receiver Power down after -15 minutes of no signal and comply with Energy Star Power consumption limits of < 0.5W in standby Yellow LED (Front Panel) to indicated Standby mode is active Terminal Block analog audio inputs on 2 CH amp 2 x amplifier outputs, bridgeable to 1 channel Volume, Auto on/off signal sensing Natural cooling without Fan TRIGGER could be external remoting ON/OFF Short circuit protection Overheating protection Specifications Dante Audio Interface 2x2 audio channels I2S digital audio format 16, 24 or 32-bit audio samples (per device or per channel) 44.1 KHz, 48KHz, 88.2KHz and 96KHz sample rate Network Interface Standard 100Mbps Ethernet RMII Ethernet interface with MDIO Hardware time-stamping, supporting sample-accurate playback Transmit flows: 2 (unicast or multicast) Receive flows: 2 (unicast or multicast) Latency from 2ms Amplifier/ Rated Power 4ohm Stereo Mode = 120W (22 V) RMS output (steady state). per channel @ < 1 % THD+N Bohm Stereo Mode = 120W (31 V) RMS output (steady state), per channel @ < 1 % THD+N 70V Bridge Mode= 240 W output (steady state), per channel@ < 1 % THD+N 100V Bridge Mode= 240 W output (steady state), per channel@< 1 % THD+N 1/8 Rated Power Run Time: continuous operation Frequency Response: 20Hz-20kHz +0/-2dB @ 4ohm load Signal to Noise: >90dB A WTD Dimension: 214mm(W) x 249.Bmm(D) x 44mm(H)
