Description Mid board, both rollers press down on the work. The load is shared and the machine sits where it sits. At the start and end of the cut, only one roller is engaged. The same downward force now goes through half the contact points. The head assembly flexes, the cutterhead drops a few thousandths, and it takes a deeper bite. That bite is your snipe. This is why the standard advice only half works. Support tables, sacrificial boards, lighter passes, and lifting the ends all reduce the load a little. None of them remove the difference between one roller carrying it and two. What the kit does The kit adds adjustable stops that limit how far each roller can compress. Cap the compression, and you cap the swing in load between one-roller and two-roller contact. Less swing, less flex, less snipe. Same principle a floor-standing planer uses, applied to a lunchbox machine. Fitment DW735 and DW735X: confirmed fit. DW734: not currently sold for this machine. The DW734 uses different bracket hole spacing, and while some owners have made this kit work by modifying the mounting holes, we do not recommend it and do not support it. A dedicated DW734 set is on the list. DW734 owner? Leave your email and we will tell you when it is ready. Install 20 to 40 minutes. No drilling, no permanent modification, fully reversible. A dial indicator makes dialing it in much easier than feeler gauges. Recheck the adjustment after blade changes, the same as any tuned machine. In the kit 4 set screws with locknuts for infeed and outfeed adjustment8 steel hex bolts0.02 FL. OZ. (0.5ml) Loctite 242 to secure the hex boltsPH2 bit for stock screw removal2.5mm and 4mm ball end hex bitsQR code to the installation instructions: Link Guarantee Saves your first board or it is on us. 30 days, full refund.
