Ramuc Type A-2 Rubber-Based Pool Paint is formulated specifically to refinish pools previously coated with chlorinated or synthetic rubber paint. It provides excellent coverage, a high-gloss finish, and long-lasting protection against pool chemicals and weathering. Ideal for both residential and commercial pools, this VOC-compliant formula is safe to use in all U.S. states and Canada. Why Choose Ramuc Type A-2? For Recoating Rubber-Based Finishes: Bonds directly to existing chlorinated or synthetic rubber pool coatings - no primer needed. Easy Application: Self-priming two-coat system applies with a standard roller or airless sprayer; dries quickly with low odor. Glossy, Easy-to-Clean Finish: High-gloss surface resists dirt and stains for a professional appearance with minimal upkeep. Long-Lasting Protection: Durable synthetic rubber formula resists UV rays, chemicals, and seasonal weather changes. VOC Compliant: Meets environmental standards in all 50 U.S. states and Canada - safe for indoor and outdoor use. Quantity Calculator Use the table below to type in the dimensions of your project area, then click the Calculate button to determine the amount of Ramuc product needed for the job. Length (ft): Width (ft): Depth (ft): Total (sq ft): Total rounded to nearest whole number. Total assumes a bottom and four walls. Epoxy Projects Product Bare/Sandblasted/Rough Surface Fiberglass/Recoat EP Epoxy Hi Build Epoxy HB31 Rubber Projects Product Bare Surface Recoat A-2 Acrylic Projects Product Prepped Surface/Recoat DS ADC* Total amount rounded up to nearest whole number. Amounts shown are for 1 coat.*ADC product amount should be calculated by L x W only. Surface Preparation & Application Clean thoroughly using Ramuc Clean and Prep Solution; power wash to remove dirt, chalking, and loose paint. Repair cracks or weak areas with hydraulic cement or polyurethane sealant (avoid silicone-based fillers). Check surface dryness with a condensation test before painting. Apply two coats using a 3/8” mohair or lambskin roller - box multiple gallons for color consistency. Avoid rain during the cure period; extend drying time if rain occurs. Not Recommended For Bare fiberglass, hot tubs, or spas (use Ramuc EP or Hi-Build Epoxy instead) New or uncoated surfaces (Type A2 is not intended as a first coat) Dark colors as full-pool finishes - use only as accents (risk of fading or blistering)
