Unsure if this is the right bracket for your vehicle? Take our quiz above to see what bracket you need. The No-Drill Taxi Plate Holder/Bracket from MOGO ‘Rear/Front - For Small Licence Plates’ is used for fitting a Small Licence Plate (240 x 125mm) to a vehicle where only minimal clearance from the bodywork is required. This Bracket provides up to 20mm clearance only. This is the most condensed of the Mogo mounting brackets. Quantity Breaks on larger orders available, Contact us today for further information. Not sure which bracket you need?Download our Bracket Selection Guide here: Bracket Guide PDFNeed help fitting your bracket? View our step-by-step Fitting Instructions: Fitting Instructions PDF Now a firm favourite within the taxi trade, the MOGO No-Drill Bracket System offers a quick, secure, and drill-free method for fitting licence plates to a wide range of vehicles. Installation is straightforward: simply remove the number plate by unscrewing the existing fixings, position the MOGO bracket behind the plate, and replace the screws. Sticky pads are included for additional support where needed. This version of our Taxi Plate Holder is specifically designed for vehicles with significant bodywork depth around the rear plate area — such as vans or minibuses where bumpers protrude noticeably. Why choose MOGO brackets? Manufactured from high-quality polycarbonate — designed for long-term use with near-unbreakable durability Easy, no-drill installation that takes just minutes Supplied with a full FS-1 fixing kit: 4 secure locking pins 2 sticky pads Fitting instructions (also available here) Compatible with most vehicles, although due to the wide variety of makes and models, a perfect fit cannot be guaranteed in every case Cable tie packs are available separately for non-standard installations Brackets are typically installed to display the licence plate below the registration plate, but they can also be inverted to display it above — depending on your specific vehicle or licensing requirements.