Warning This product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, NOT for DIY users, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. This product does not include serial number. For the most accurate and latest information related to this topic, please refer to the official governance website of your country. Overview Holybro RemoteID Module is a low-cost, small-sized, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is an FCC and CE-approved radio module. The products run open-source firmware (ArduRemoteID) and provide a so-called standard Remote ID solution, primarily targeting drone manufacturers & system integrators. If you need customization or have a special request, feel free to reach out to us via email. Specification Radio module: Espressif ESP32-C3 module Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW) FCC & CE certified radio module Firmware: ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID). Supports upgrading firmware via the web interface (“OTA”) Supported in PX4 & Ardupilot (More Info) Protocol: CAN & Serial Interface: 1x JST GH 4-pin CAN (CAN) port 1x JST GH 6-pin TELEM (UART) port Antenna Connector type: On CNC Case: SMA connector On PCB: IPEX Connector Range: > 5km detection range* Power: 5V supplied from TELEM or CAN port LED lights: Bright RGB status LED Dimensions: Without case: 35.3 x 23.5 mm (not including antenna) With CNC case: 38 x 26.5 x 11.5 mm (not including antenna) Mount: M2 screws Operating temperature: -40°C to +85°C Weight: PCB only: 4 g With CNC case & Antenna: 27.5g Without case & Antenna: 16.5g (Cable 20cm) Certification: FCC & CE * The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height, line of sight, etc. With professional receivers, a range of 5 km or more is possible. Guides & Reference Links Holybro Doc Setup & Configuration Guide Firmware Update Guide Firmware support Ardupilot Ardupilot Wiki - RemoteID Ardupilot Wiki - OpenDroneID FW building PX4 PX4 Guide on Remote ID/OpenDroneID FCC Identifier: 2AP22-REMOTEID PINMAP Package Includes： 1x Remote ID 1x Antenna 1x JST GH 6pin 150mm Cable 1x JST GH 4pin 150mm Cable
