Overview Holybro RemoteID Module is a low-cost, small-size, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is a FCC and CE-approved radio module. The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone manufacturers & system integrators. Specification Radio module: Espressif ESP-C3 module Bluetooth and WiFi 2.4GHz (ERP): + 20 dBm (100 mW) FCC & CE certified radio module Firmware: ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID). Supports upgrading firmware via the web interface (“OTA”) Supported in PX4 & Ardupilot Protocol: CAN & Serial Interface: 1x JST GH 4-pin CAN (CAN) port 1x JST GH 6-pin TELEM (UART) port Antenna Connector type: On CNC Case: SMA connector On PCB: IPEX Connector Range: > 5km detection range* Power: 5V supplied from TELEM or CAN port LED lights: Bright RGB status LED Size: Without case: 35.3 x 23.5 mm (not including antenna) With CNC case: 38 x 26.5 x 11.5 mm (not including antenna) Mount: M2 screws Operating temperature: -40°C to +85°C Weight: PCB only: 4 g With CNC case & Antenna: 27.5g Without case & Antenna: 16.5g (Cable 20cm) Certification: FCC& CE * The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height line of sight etc. With professional receivers a range of 5 km and more is possible. PINMAP Package Includes： 1x Remote ID 1x Antenna 1x JST GH 6pin 150mm Cable 1x JST GH 4pin 150mm Cable
