An IP67 panel-mount RJ45 bulkhead connector with a 20cm CAT6 pigtail: the clean way to get ethernet into a weatherproof enclosure. The threaded receptacle mounts through a 13/16" hole and seals against the panel with an included gasket. Inside, a 200mm CAT6 cable with a standard RJ45 plug connects straight to your gateway, router, or Ethernet module. This is a must-have component if you're building a Meshtastic gateway with something like a RAK13800 Ethernet module or Raspberry Pi, or another POE node. Key Benefits 🛡️ Sealed Enclosure Entry. IP67-rated when locked, with a waterproof gasket to seal to your enclosure and a threaded gasketed cap when not in use. ⚙️ Tool-Free Hookup Inside. The internal 20cm pigtail ends in a standard RJ45 plug. Plug it into your board and close the lid. No re-terminating, no punch-downs, no additional cables needed. 📡 Built for Outdoor Duty. Threaded coupling, -25°C to +80°C operating range, and a rugged TPU-jacketed CAT6 cable. It's a stiff cable, but durable enough to handle tight bends to make the connection. The outside face is an RJ45 receptacle (female jack) with 13/16"-28UNS threading. It reaches its full IP67 seal when a mating locking connector or the included dust cover is installed. A standard unsealed patch cable plugged into the front will pass data but won't keep water out of the jack itself. Specifications Type Panel-mount RJ45 bulkhead receptacle with internal RJ45 pigtail Cable Category CAT6 UTP, 4 pair x 24AWG + 1C x 26AWG, straight-through wiring Cable Length 20cm ± 10mm (approx. 8 in) Cable Jacket Black TPU, 6.5mm OD Panel Cutout 13/16" hole, panels up to 3mm thick Ingress Protection IP67 (when mated or capped) Operating Temperature -25°C to +80°C Voltage 60V DC PoE Coverage 802.3af / at / bt Type 4 (90W), all passive variants Data Cat5e / 1 Gbps, shielded (SFTP) Durability ≥500 mating cycles Compliance RoHS, IPC-A-620 quality standard Manufacturer CAZN What's Included Panel-mount RJ45 female bulkhead with 200mm CAT6 pigtail male connector Rubber o-ring gasket Hex mounting nut (13/16"-28UNS) Threaded cap with integral o-ring and tether Compatibility Drops into any enclosure wall up to 3mm thick: drill a 20.6mm (13/16") hole, seat the gasket, tighten the nut Works with Ethernet-connected Meshtastic™ gateway builds. The internal pigtail plugs directly into modules like the RAK13800 Ethernet module Standard RJ45 on both ends, no proprietary connectors, no special tooling
Related
Related
Related
Related