Brand new aftermarket stator. Direct replacement to the original unit Plug-and-play, direct fit, easy installation. Highest grade lamination materials Highest grade copper windings, resistant to 200 degrees Celsius. Pick up pulsar coil included Connector included Rubber grommet included All products shipped are tested All item pictures are accurate; if in doubt do not hesitate to compare The item to the original part.Before Installing the New Stator Check the AC output of the stator. Replace any burned or corroded connectors on stator and regulator/rectifier Check and repair any melted wiring. Use hi-temp dielectric grease on all connectors The stator may use a different wire colThe code than the original. All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound. If The stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010’’.Warning: Risk of electric shock. Disconnect the battery before servicing. Ensure proper installation by a qualified technician to avoid malfunction.Dimensions: Interior diameter : 28 mm Exterior diameter : 84 mm Thickness : 12 mm Length of wires stator to grommet : 82 mm Length of wires grommet to plug : 400 mm Length of pickup coil's wire to grommet : 40 mm Other Specifications: Number of wires : 6 Number of plugs : 3 Number of pins : 6 Wire to wire resistance : Alternator : White To Yellow = 0.6 ohms ±20% Pickup : = Green To Red = 100 ohms ±20% Source : Red/White To Black/Red = 15 ohms ±20%