Rode NT6 Compact Condenser Microphone The NT6 is a small-diaphragm cardioid condenser microphone with a remote capsule, specifically designed for difficult mounting applications where the highest quality audio is required. The microphone is split into two modular components that are connected via a custom 3-meter shielded, Kevlar-reinforced cable. The head features a 1/2-inch gold-sputtered condenser capsule with a multi-position mounting ring that provides 180 degrees of vertical rotation. The body houses the microphone preamp, which features a high-pass filter (80Hz) and a -10dB pad. Key Features: Premium small-diaphragm condenser microphone with remote capsule 1/2-inch gold-sputtered Two-stage pad, two-stage high-pass filter Ideal for difficult mounting applications Miniature Detached Capsule and Body A 10' Kevlar-reinforced microphone cable joins the miniature capsule and output stage. This design provides endless mounting possibilities on instruments, the ability to capture room ambiance, and more. Swivel Mount The 2-position swivel mount allows both horizontal and vertical pivoting of the capsule for accurate positioning. Also included are 2 thread adapters (1/4" to 5/8" and 1/4" to 3/8") which enable attachment to virtually any microphone stand. Cardioid Polar Pattern The cardioid polar pattern effectively suppresses off-axis audio, reducing residual noise caused by ambiance and feedback. Low-Frequency Roll-Off A low-frequency roll-off switch eliminates noise and rumble below 80 Hz. -10 dB Pad Switch A -10 dB pad switch provides added headroom for capturing signals that exhibit excessive levels and transients. The pad allows these signals to be captured without noise caused by distortion and overload. Specifications Analog Performance Operating Principle Pressure Gradient Transducer Condenser Diaphragm 0.5" / 12.70 mm Polar Pattern Cardioid Frequency Range 40 Hz to 20 kHz Signal-to-Noise Ratio 75 dB Equivalent Noise Level 19 dB A-Weighted Maximum SPL 135 dB SPL Pad -10 dB THE 1% Impedance 200 Ohms Sensitivity -37 dB Dynamic Range 119 dB General Output Connectors 1 x 3-Pin XLR Operating Voltage 24 V48 V Length 7.44" / 189 mm Diameter 2.52" / 64 mm Weight 0.85 lb / 386 g
