Rounded rectangle resin display plinths, cast in strong black pigmented resin. These have been specifically designed with squads in mind. There are 3 widths available (50mm, 60mm and 70mm) along with 3 lengths in each (150mm, 200mm and 250mm) This should accommodate groups of models of all sizes. Each plinth has been created hollow, this serves to reduce weight, aid shipping and allow a range of modelling opportunities. A wide rim 10 - 15 mm rim has been left to allow somewhere to drill for transportation magnets (not supplied). After casting each plinth is machine sanded to ensure the top and bottom surfaces are parallel and true. I inspect each plinth and fill and sand any imperfections, although sometimes I miss things. The finished height is approximately 35mm once machined, this height can vary plinth to plinth but I always aim to match finished heights across multiple plinths in an order. Now offering Magnet or Screw inserts for your plinths PRODUCTION - PLEASE READ! Due to the amount of resin required to produce these plinths they will be cast to order. This can mean a lead time of up to a week prior to shipping. I would always recommend ordering ahead of time if you require them for a competition. I will always strive to cast items immediately and aim to get orders out the next day. Your plinths may arrive in a sanded and prepared state, each and every plinth I cast is meticulously inspected for imperfections these are then filled and sanded out. PREPARATION Prior to use it is recommended to clean each piece is warm soapy water to remove residue release agent. Persistent release and silicone residue will remove with spirit based fluid and an old tooth brush. Wash in water after using spirit based cleaners. If any small bubbles are present they can be filled with superglue applied from a pin tip and sanded back. Always wet sand resin using fine grit wet and dry, sanding from course to fine paper to remove surface marks (240, 320, 400, 600 grit for example). I would always recommend spraying your plinth in a flat coat of black to even out the colour. DISCLAIMERS This web store and its contents is owned and run by Taro Modelmaking Ltd, an independent company producing third-party kits and accessories for wargaming and scale miniatures. All product images are for illustrative purposes only, used to demonstrate compatibility and scale with popular 28mm tabletop systems. Demonstration models shown can be purchased elsewhere and are not manufactured by Taro Modelmaking Ltd. The products sold on this website are designed and manufactured by Taro Modelmaking Ltd These are for adult use only, not intended for use by children under 14 years old. May contain small parts which can be a choaking hazard. Cast from polyurethane resin. Every effort is taken to prevent bubbles, although some small bubbles may remain. All measurements are approximate due to resin shrinkage as environmental conditions change during the casting process. Heights are Approximate and can vary each way by a few millimetres. Supplied unpainted
