Optimization controller for wood stove, pellet stove, and outdoor wood boiler installations Bolt-on controller that converts a manual-damper / thermostat-only setup into closed-loop combustion control. It continuously reads the system state and adjusts damper, blower, or feed-rate to hold the target output. This avoids the chimney-loss / creosote / overheating tradeoffs of running open-loop. Pre-configured kit — no ladder programming. Why this controller vs. the conventional setup Automated closed-loop adjustment — damper / blower / feed-rate control based on temperature feedback. Multi-point temperature sensing — combustion-zone, outlet, and ambient sensors keep the controller in the loop on actual stove state. Pressure monitoring — for hydronic boiler installs (closed water loop). Safety interlocks — over-temperature, runaway combustion, and pressure-excursion protection. Indoor and outdoor compatible — freestanding indoor wood stoves, pellet stoves, and outdoor wood boilers feeding hydronic systems. Pre-configured kit — fast setup, no ladder logic, no control-theory expertise required to install. Specifications Application: wood stove, pellet stove, outdoor wood boiler Control modes: closed-loop damper / blower / feed-rate based on temperature feedback Sensing: multi-point temperature, plus pressure (boiler installs) Safety: over-temperature, runaway combustion, pressure-excursion interlocks Indoor/outdoor: both supported Form factor: pre-configured kit, fast setup Origin: Designed and assembled in Pittsboro, NC Datasheet: full specifications (sensor count, output channels, supported stove brands, hydronic loop interface, electrical input) available on request — contact us. FAQ Will it work with my specific stove or boiler brand? The controller is brand-agnostic for the underlying control variables (damper actuator, blower, feed motor, temperature/pressure sensors). For brand-specific compatibility — especially pellet-system auger / ash-removal integration — contact us with your stove/boiler model and we will confirm fit. Does it work with hydronic outdoor wood boilers? Yes. The kit includes pressure monitoring on the closed water loop. Confirm pump-control / zone-valve interface with us before ordering. Will it reduce my fuel use? Closed-loop combustion control consistently outperforms manual-damper operation on every fuel-loss vector: chimney loss, incomplete combustion, and overheating in mild weather. We do not publish a numeric percentage without source-doc verification. The magnitude depends heavily on your stove, fuel, and operator habits. Is this a consumer product? No — this is OEM/installer-grade. Installation requires hands-on wiring, sensor placement, and damper/blower actuator setup. Serious off-grid / wood-heat homeowners with technical skill do install it directly. Otherwise plan for an installer. Compliance & origin Origin: Assembled in Pittsboro, North Carolina, USA. Components come from global suppliers. Final assembly, firmware, and QC happen in the NC workshop. Application: residential and light-commercial wood / pellet combustion only — not for gas, electric, or industrial boilers. Support: ticket-based support direct from the people who built the hardware — open a ticket. Warranty & certifications: available on request — open a ticket for the current scope. Documentation & warranty Full technical datasheet, installation guide, and warranty terms are available on request. Ticket-based support direct from the manufacturer in NC. Request datasheet Request a quote
