Quest Screen House 6 This is the Quest Screen House 6. The original and still the best quick erect shelter on the market. The Screen House 6 is available in two sizes and is simply the original, quickest, easiest and best gazebo on the market. It has 6 sides and is built and designed so one person can erect (or take it down) in less than one minute. There is nothing to build, put together, tension or inflate, you simply take it out of the bag, unfold it and pull/push the sides and roof and it springs into position - fully set up and ready to peg. It uses the latest generation premium hub system which has been improved on again making it smaller, lighter and more durable, whilst maintaining its ease of use and ability to be repaired if required. It comes with pegging points on every corner and in the middle of each side giving you great ground anchorage. It has storm straps on every side ensuring it stays up in adverse weather and makes it sturdier than any gazebo you are used to. The premium Pmesh panels are built in, these help keep you warmer in the wind and cooler in the sun, but allow the air to flow ensuring no gas build up can occur inside. The roof is waterproof so it keeps the water off and the U.V. coated Quest Tec 210 material gives you a U.V. rating of 50+ keeping you safe from the Suns rays. Step 1: Get into Position You simply take the screen house out of the bag and place it on the ground, holding the frame place the black circular end on the ground. This is actually a very important step as this helps ensure you erect the screen house correctly. Once done you simply let the sides fall to the fall at which point you will see the green roof material facing upwards. Then finally place the frame on the ground as well. Step 2: Erect the screen house Next you walk around the screen house and open the sides up (there are 5 in this model). You do this simply by holding the storm strap with one hand, whilst the other holds the top of the side. Pull the storm strap towards you and this will cause the side to spring open. Repeat this on each of the sides. This only takes seconds for each side. Once all sides have been done, simply walk into the centre of the screen house and push the centre of the roof up. The roof will then spring into place. Then place the two front poles in the pockets provided at the top and bottom of each corner of the door. The screen house is now erected, but we recommend that you peg the screen house down in case of windy conditions. Step 3: Peg (Recommended) There is a pegging point at every corner of the screen house and in the middle of each side. On top of these points each side has a storm strap located in the middle of the sidewall, peg this down by pulling the storm strap away from the screen house, but keep the strap loose. Once pegged tighten the storm strap, but do not over tighten as it could pull the screen house out of shape. Step 4: Optional Extras: Sidewall Blinds You can also fit sidewall blinds if you wish. These give you more privacy and protection against the weather. Every side and the door can have a sidewall blind fitted if you so wish. To fit the sidewall blind simply unclip the storm strap, place the sidewall blind over the side clipping it in place in each comer. Ensure the ring in the centre pushes over the hoop where the storm strap fits onto and finally just attach the Velcro tabs on the top and sides. The screen house gives you a huge amount of usable space as the sides spring out ensuring you can use 100 of the space inside. The screen house has fully screen sides all around so there is nothing to add afterwards. The screen walls stop those pesky insects getting and actually help keep the wind at bay, but allows airflow to keep it cool. In sunny weather the UV coating and shade from the roof along with the fully screened sides actually make the inside of the screen house cooler than the outside. Easy to put up, just as easy to take down and pack aw - Normal lead time 3-4 days
