Retaining the body sides of full width type bodies gets more important the faster you go. R clips can be a pain, easily lost and less than tidy This kit includes a rear top mount, a two pairs on mounts for the dies and one pair for the front. Genuine Dzus 1/4 turn fasteners used to make body fit easy. We've been using this Quick Release system on our 224mph World Record speed car, our Arrma Speed Car and Hobao Drag car, and it's fantastic! The body can be removed in seconds. The rear to mount uses a carbon fibre plate and billet machined aluminium end brackets to accept the genuine Dzus fasteners. The width has three settings, two as per the Arrma stock part, which this can directly replace, and then a third extra wide setting to give bodies lots of support. The side mounts are now ALUMINIUM (colour is silver, rather than the pictured black). Three Pairs are supplied in the full kit, two for either side and one pair to be mounted on the front splitter. The chassis / splitter must be drill and countersunk. Our SPC2 Carbon Chassis is ready drilled to accept these parts! We're working on pre-marking our splitters too. This only works with bodies that have a flat area at the back, and flat sides - Delta Plastiks GT1, Ford and Jag bodies are fine. The Dome body for example will not be compatible because it does not have a flat area at the rear. Modifying your RC from stock condition can result in unexpected results. Operation of modified models must take this into account. Always follow the original manufacturers instructions. Whilst we build our parts to the highest standards we are able, like all rc parts, our parts cannot be guaranteed for performance, strength and durability in every situation or configuration. Do not use your RC in public areas. Do not use your RC where unexpected results could cause injury or damage to property. High Speed RCs require GREAT CARE and a responsible attitude to use safely.
