What is this?- This is a cover to hide the hole left after the side markers have fallen out or were removed. What you're getting- One set of raw 3d printed covers with 3m double sided tape pre-installed. Material- PETG Version Descriptions- V1- Small square canard V2- Large curvy canard V3- Flat with three "spikes" V4- Flat no design Fitment Guide- BRZ- V1,V3,V4 FRS-All 17+GT86- V1,V3,V4 V2 can be heat molded to any bumper but was designed using an FRS bumper. Do at your own risk. Installation tips- For V1, Use light heat to help mold cover to bumper. V1 is flexible however some heat will make for a better result. For V2, Use heat to help mold the cover to bumper. This is due to the large canard limiting flexibility. For V3 and V4 ,No heating is required for shaping due to them being more flexible. For All, Peel 3m, line up body lines to desired location and stick. For best results it is recommended to sand then wrap/paint the covers. Disclaimer- These are raw 3d prints so some minor surface imperfections will be expected. V2 can be heat molded to any bumper but was designed off FRS bumper. Do at your own risk. All versions were designed using a free FRS scan from GrabCAD.
