Fixing instructions:1. One unit is required for each side of the vehicle.2. Attach the flasher unit to a solid part of the vehicle, within the junctionbox or close to the cables for the marker light feed, so that the unit can beconnected in line.Wiring: This unit is rated at 1.0Amp. This is the maximum current draw that can beapplied by the side markers being made to flash.If the current draw is higher, multiple flasher control units will be required. Each unit is supplied with:IN - 3 way AMP Superseal female, AMP282087-1Pin 1 - Ground = WHITEPin 2 - Side marker = BLUEPin 3 - Indicator (YELLOW/BLACK) OUT - 2 way AMP Superseal male, AMP282104-1Pin 1 - Ground = WHITEPin 2 - Side marker = BLACK To the IN connector, connect the flasher unit in-line on the marker light feed,and take a wire from the indicator circuit on the same side of the vehicle andconnect to Pin 3 (YELLOW/BLACK).From the OUT connector, link the GROUND and POSITIVE to the wiresfeeding the marker lights. PM-5001 Side Marker Flasher Control Unit12/24V operating voltage, 10-30Vdc range 3-core sheathed cable (power in) - terminated in 3-way AMP Superseal female connector2-core sheathed cable (power out) - terminated in 2-way AMP Superseal male connector LED or incandescent lamps EMCDirectiveECE R10:This side marker flasher control unit has been approved to Automotive EMCDirective ECE R10.05.0983Good installation practice should be followed to ensure that compliance withthese directives is maintained, and a qualified electrician should be consulted.ProductdescriptionThis product enables the vehicle side markers to flash synchronously with thevehicle’s direction indicators when the indicators are activated. One unit isrequired for each side of the vehicle. AMP50 version includes rubber boots covering the connector/cable interface EMC certified to ECE Reg 10.05 Designed for simplicity of installation IP67 compliant
Related
Related
Related
Related