Silicon Carbide Powder is a perfect tool for flattening and lapping synthetic and natural stones. Choose one of 5 available grit: F 80, F 120, F 280, F 500 and F 1000. One bottle contains up to 100 gram of SiC powder. F 80 Flattening of very coarse stones (60 - 150 grit) F 120 Flattening of any stones (180 grit and above) F 280 Lapping of medium waterstones (400 - 1000 grit) F 500 Lapping of fine waterstones (2000 grit and above), natural stones, alumina ceramic F 1000 Lapping and honing of ultra-fine natural stones and sintered alumina ceramic How to useWarning! Respirator required to work with F1000 silicon carbide powder. Inhalation can cause illness.The SiC powder should always be coarser than a sharpening stone.Take a slate pencil and put crosshatch pattern to the surface of the stone. Never skip this step. Your goal is to get rid of crosshatch completely. If you notice left-over of pattern somewhere, it means geometry is not flat yet.Always add water to make a suspension, not dry SiC. Try to use glass area evenly. Your glass will wear over time because SiC affects glass too.For hard stones, coarse SiC will be the major time consumer. When SiC disintegrates, put another pinch (refresh). If there is too much suspension, clean your glass. Use a straight edge or metal ruler to check flatness. If you are not sure, make crosshatch pattern again.The abrasive hygiene should be a priority. Don't let single coarse particle to remain in fine lapping.
