The SpeedyBee F7 V3 Flight Controller is an F722 FC featuring a BMP280 barometer, OSD, 500MB Memory Blackbox, a built-in FC LiPo monitoring system, and many more features. Equipped with solder-free connectivity options, this FC is the perfect addition to your FPV build. VIDEO: SpeedyBee F7 V3 Flight Stack - Everything But The Kitchen Sink Features 500MB Onboard Blackbox Flash memory 8 Motor output perfect for X8 Cinelifters 30.5 x 30.5mm Mounting Pattern FC LiPo Monitoring System Built-in Barometer 4 LED Plugs F722 FC Buzzer Specifications Power Output: 1) 10 groups of 5V output, three +5V pads and 1 BZ+ pad (used for Buzzer) on the front side, and 6 +5V output included in the connectors on the bottom side. The total current load is 2A. 2) 2 groups of 9V output, one +9V pad on the front side and the other included in a connector on the bottom side. The total current load is 4A. 3) Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load Supported. Designed for 3.3V-input receivers. Up to 500mA current load. WiFi Support, used for data transfer, e.g firmware flashing, and Blackbox analysis. I2C: Supported. SDA & SCL pads on the front side. Used for magnetometer, sonar, etc. Support Flight Controller Firmware: BetaFlight ESC signal M1 - M4 on the bottom side and M5-M8 on the front side. LED: Used for WS2812 LED controlled by Betaflight firmware. UART: 5 sets (UART1, UART2, UART3, UART4, UART6) DJI Air Unit plug: A full DJI Air Unit JST slot onboard BLE Support, used for Flight Controller configuration Buzzer: BZ+ and BZ- pad used for 5V Buzzer Mounting: 30.5x30.5mm, 4mm hole size Dimensions: 41(L) x 38(W) x 8.1(H)mm OSD: BetaFlight OSD w/ AT7456E chip BlackBox: 500MB onboard data flash BetaFlight Camera Control Pad: Yes ESC Telemetry: UART UART4 RX Power input: 3S - 6S Lipo Target: SPEEDYBEEF7V3 SmartPort: Supported Baro: BMP280 (I2C) MCU: STM32F722 Boot button: Yes RSSI input: Yes IMU: BMI270 USB: Type-C Weight: 9G Links SpeedyBee F7 V3 Stack Manual Includes 1x SpeedyBee F7 V3 Flight Controller 1 4-Pin SH1.0 to SH1.0 Analog VTX Cable 60mm - Yellow and Blue 1x 6-Pin SH1.0 GPS module Cable without connector - 100mm 1 4-Pin SH1.0 to 3+ 2-Pin JST1.25 FPV Camera Cable - 30mm 1 4-Pin SH1.0 to 3+ 2-Pin JST1.25 FPV Camera Cable - 60mm 1 4-Pin SH1.0 to 4-Pin JST1.25 FPV Camera Cable - 60mm 1x 6-Pin SH1.0 GPS module Cable with connector 1 4-Pin SH1.0 Radio Receiver Cable - 100mm 1x SH 1.0mm 8-Pin Cable -30mm 5x M3 8mm Silicone Grommets 1x DJI 6-Pin Cable - 80mm
