Description Spreader Kit Fitting Guide Spreader Floodlight Kit Dimensions Description This three piece kit consists of a mid section and two spreaders. Four bolts are used to secure each spreader to the midsection. The spreaders are tapered and angled aft so that for whatever you decide to put on there it will not interfere with the radar or satdome that you have on your mount. All the wiring from your GPS unit or antenna can be routed internally through the spreaders and into the mount itself. Not only does this help with security but it also makes for a very nice and clean installation. All the parts that make up the spreader kit are bolted together with rubber gaskets in between each part to prevent any water intrusion. Each spreader kit now comes with two S.S. 1-14 threaded adapters (SP7SSV2). Comparison between the old and new V2 spreader kits illustrated here. Spreader Kit Configurations With this spreader kit there are two ways to configure it, one for a closed dome radar configuration and one for a satdome configuration. The above image illustrates what is included out of the box, including the extension posts. When you are using a closed dome radar with a spreader kit you want to raise your GPS units above the closed dome radar to avoid interference. If you are using a satdome you don’t need to use these extension posts with GPS units. You see satdome radio waves travel up to the sky to the satellites, while the GPS waves will travel horizontally. Therefore you do not want these raised above your satellite dome. How to Get the Right Spreader Kit For You There are two different spreader kits available from Seaview. The only difference between the two is the size of the midsection that mounts to whichever Seaview mount you have. The smaller of the two is the SP1MODV2. The SP1MODV2 will only fit on Seaview mounts that have a part number ending in "M1", for instance a PMA57M1. Mounts that end in "M2" for example a PMADM2M2 would use a SP2MODV2 spreader kit. Spreader Fitting Guide Use the chart below to find the part number for a specific Seaview Spreader Kit. Part # Fits Seaview Modular Mounts SP1MODV2/SP1MODBLK Fits Seaview Modular Mounts ending in "M1". For example PMA57M1 SP2MODV2/SP2MODBLK Fits Seaview Modular Mounts ending in "M2". For example PMADM1M2 Spreader Floodlight Kit Enhance your visibility with a Seaview Floodlight Kit. This kit is specifically for the Seaview Spreader Kits and comes with a Lunasea floodlight (8 WATT 1,600 LUMEN LED FLOOD). Compact outdoor light utilizing the newest high performacne LED technology. Excellent for lighting up small to medium size areas. Hard Anodized aluminum housing with Baked Urethane finish for extreme durability. Beam angle of 120 degree. Tempered Glass will not yellow like plastic lenses. Breather Valve. Cool White (5700K) IP Rating: IP67 This kit simply mounts underneath each spreader. Includes stainless steel bracket, mounting hardware and Lunasea LED floodlight). Please note that this kit is only for 1 LED flood light. Seaview Part Number Dimensions SP1MODV2 Download SP2MODV2 Download
