Low profile Starlink entry puck. VHB mounted base and matching cap plate. Comes with rubber grommet to protect wires from edge of hole cut into roof, 4 self drilling screws and sealant for around wires and between base and cap. We also make solar entry pucks. See them here: Solar entry puck Puck is 2 1/4 inch x 2 1/4 inch. Drill hole is 1", wire hole is .375 OD or .1875 OD. Locate and drill hole in van roof. Prime edge of hole and install grommet. Peel backing off VHB and center base over hole. Apply sealant in wire troughs and on top of wires and on face of base. Place cap on top of base and secure with screws. Drilling 1/16 diameter pilot holes in roof for screws is recommended. Wipe off excess sealant. Cover with Dicor or equivalent if desired. Not required. DISCLAIMER: Owner and/or installer assumes all risks associated with products and/or components purchased from DIYvan. Owner and/or installer recognizes and agrees that this product, and any of its component parts, is sold “as is” and that DIYvan makes no representation or warranty of merchantability that the product is fit for any particular purpose.
