This unisub sublimation blank was created solely for using with the transfer that comes with purchase. Finished Size | W .65" H .6" MDF Unisub - approx. 2.8mm thick Acrylic Unisub - approx. 4.6mm thick ✔️ Sold as 4 pair (8 pcs) NO Hardware included ✔️ Comes with blank substrates and transfers ✔️ Gloss (clear film) Matte (blue film) Acrylic (clear film both sides) ✔️ Hardware is not included with stud blanks purchase. Purchase at your local craft store or online. ✔️ I use a tiny dab of this to adhere hardware to blank ( CA Adhesive Thick) ✔️ Backside of single sided mdf blanks are unfinished and may have some burn marks around the edges due to the nature of being laser cut. PRESSING INSTRUCTIONS for Unisub MDF: Remove all the clear or blue film from the substrate. Remove residue, if any, with a soft damp cloth from unisub MDF. Place your MDF substrate onto your transfer and secure with heat tape. Press for 55-60 seconds @ 380 degrees medium pressure. (Time and temp may vary based on your heat press PRESSING INSTRUCTIONS for Unisub Acrylic: Remove the clear film from both sides of the substrate. Place your acrylic substrate onto your transfer and secure (white side against transfer). I use 3m repositional spray so I do not end up with tape indentions on acrylic. Press for 120 seconds @ 355 degrees medium pressure. (Time and temp may vary based on your heat press) Immediately remove and apply heavy even pressure on a smooth flat surface to cool so it will not warp. Make sure all surfaces are clean of grit (all will cause indents on substrate) Join the Pioneer Supplier and Creations VIP on Facebook for new releases and sales! Blank Sublimation Unisub Acrylic and MDF, Ready to Sublimate
Related
Related
Related
Related