name SUBQ ===> subcutaneous (note: the first batch of 5 have sold out, these are now preorders with a 1.5 month lead time.) _____________________________ case dimensions 35mm case width 46mm case length (40 mm lug hole to lug hole) *whoever said good things come in small packages obviously never worked w/ integrated straps ;) strap dimensions 125mm cut to size strap length w/ strap fitted to the watch, there is an internal circumference range of 140mm up to 280mm _____________________________ about the watch tldr; took a nylon skeleton and injected a f****ing chemical reaction around it with a hypodermic needle to make a watch out of fancy glue. if you think that's absurd, you're absolutely right. more info for the nerds below. subcutaneous: meaning situated or applied under the skin - SUBQ references 2 aspects of the watch, the manufacturing and the design. manufacturing SUBQ's are made using reaction injection molding. this is a subcutaneously injected urethane reaction into a soft platinum silicone mold of the watch case that has been pre-loaded with a nylon skeleton. this has to be done cognizant of gas infiltrations and within 3 minutes of the reaction. gas infiltrations can be intentional, the result of higher atmospheric humidity, or occur by poor technique of the subcutaneous injection method. the result of such a volatile process is a graveyard of rejects. not every injection process yields the demanded results and while variables can be tuned, there is a luck aspect. similar to how enamel dials are made, however there is significantly less chance of running a hypodermic needle through your hand in that process. design SUBQ also references the subcutaneous skeleton seen in the case body and the strap. the 3d printed nylon 12 skeleton is pre-loaded into the mold before the manufacturing reaction process of the case body. this skeleton provides a reinforcement of the strap and a visual design nod to the previous previous iteration of resin watch design, an octagonal case. the watch is a reverse monobloc case (reverse monobloc is made tf up but I'll explain it in a sec) powered by a ST2130 movement in a 60 psi forged urethane body that withstands 6 bars of pressure underwater. reverse monobloc (see i told you I'd explain it) means the case body is formed directly to the front crystal to get a pressurized and seamless fit. the case back is then gasketed and press fit. to service this watch or open it, follow the instructions that you would for any monobloc case watch. be sure to press the front crystal down on the table and wrap the watch case in a towel so the back crystal doesn't fly off when pressurizing the case body. ___________________________________________________________________________ pricing it wouldn't be clear if I wasn't transparent on how it's made and the price ;) male split stem = 13.87movement = 53.00female stem = 15.82case tube = 1.95shipping occurrence 1 = 8.86case back gasket = 1.17shipping occurrence 2 = 8.86seconds hand = 4.45hour & minute hand = 5.95shipping occurrence 3 = 8.86crown = 25.95front crystal = 25.00back crystal = 35.00shipping occurrence 4 = 8.86resins & materials = 37.75 packaging = 25.00 nylon 12 structures = 8.10 ________________________________________ total cost of materials: $288.45 ________________________________________ hours to inject, forge, & clean: 2 hrs. hours for assembly & finishings: 4 hrs. hourly rate to build: $40 hourly rate x hours to build: $40 x 6 hrs. = $240 ________________________________________ total price per watch = $528.45
