The DCA Super Sabre Vanes are scientifically developed to be ultra Stable, ultra Quiet and ultra Tough!These vanes were scientifically developed over 2 years, tested using computational fluid dynamics (CFD), stability calculations, a custom-made wind tunnel, and a LabRadar (Doppler radar).NEW MATERIAL: Rev 2.0 is a new material that is ridiculously tough. The material can be stretched and returned to shape. Pass-throughs on targets are no problem. The material also has much better adhesion and can be used with all known vane adhesives after wiping the base of the vane with 70% alcohol wipe or primer pen.NEW MOLD: The Super Sabres Vanes are all very consistent. Shown by the weight consistency of 7.1 +/-0.1 gr. All exactly identical. The 8-cavity mold means there will not be any shortages moving forward.Recommended adhesives: Loctite 401, AAE Max Bond, Bob Smith Maxi-Cure, and more.Recommended Application Method:Clean the arrow shaft or wrap with a clean, dry paper towel.Place Super Sabre in the fletching jig clamp.Clean the base thoroughly using 70% isopropyl alcohol wipe or primer pen. Rewet alcohol wipe with 70% isopropyl alcohol if it dries.Apply adhesive to the bottom of the vane. Ensuring the entire surface is covered.Using the clamp, press the vane down holding it securely for 10 sec. (or recommended time on adhesive)Unclamp the vane and wipe excess glue from around the base of the vane.Let the adhesive cure for 15-20 min. (or recommended time on adhesive)SHOP ALL VANES
