Get your daily dose of fiber with this swirly sheep! Anyone can put together this quick and easy kit, no special skills or tools are needed. This crafty decoration is created by twisting together a simple circuit with your fingers. In each kit we provide the following, all you'll need is a phillips (+) screwdriver. Full instructions are here! 1 - CR2032 Battery1 - Battery Holder2 - Yellow, 3mm LED2 - Green, 3mm LED2 - Blue, 3mm LED3 - Red Wires6 - Blue Wires3 - 470 ohm Resistors2 - Wood Screws1 - Swirly Sheep Ornament About the Kit: This super cute artwork is by Maria of A Needle Runs Through It, who also provided artwork for our Sock It To Me and Sweater Weather ornament kits. With this kit, we're bringing back old-school breadboards! You assemble it by sticking the LEDs through the board, wire-wrapping around them with the provided wires, wrapping the same wires around 2 screw posts, and also twisting the battery holder wires around the screw posts. This is a great activity for those new to electronics, or for old-school hacks that just want to have a bit of fun with a project that's quick and gratifying.A Note on Battery Life:It is very difficult to balance a love for All Things Blinky with small unobtrusive battery sources. We've provided a CR2032 battery and holder with this kit precisely because it's small and can't provide a ton of current (and is therefore much safer when accidentally shorted than a rechargeable lithium ion). But this means there's not a lot of overhead for the blue in each of the RGB LEDs. They start out very bright and rainbow-flashing, and then blue and magenta colors fade relatively quickly. Red, green, and yellow stick around for a lot longer, and then it diminishes to all red at the very end. Since these are holiday-themed, we were OK with this behavior. One CR2032 will generally last about 15 hrs until it completely goes out, so we recommend leaving it on for a few hours in the evening, instead of all day long. If you'd like longer battery life, you can use 2 AA or AAA batteries instead. You'll need a holder for them like this or this.
