Between 9cm - 10cm - Please read recommended instructions to get the best results - Roll slab firmly onto your surface. Gently dust your clay slab with cornflour/starch. Place the texture mat face down. Applying even pressure to the mat pushing the mat into the clay. To achieve best imprint results you will need to apply firm pressure. The more pressure the better the imprint pattern. I recommend the palm of your hand and standing to apply even pressure. Make sure you apply pressure to the entire mat. Using these mats may take a few attempts to perfect the imprint. Once you get it right you will be blown away with the imprint details. Please note these cutters are highly detailed. I recommend using cornflour and the double push method. See my hight lights on my instagram page to watch a video on how to use more detailed cutters. Made with PLA biodegradable plastic. Cutter colours will vary. Suitable for 2-4mm thick polymer clay slabs. For more detailed cutters I recommend using corn flour directly onto your cutters or brush lightly on your clay slab, this avoids the clay from sticking to the cutters. Use a pin to pick out any clay that is stuck. A great tip is to make sure your clay is firmly rolled out onto your work surface before cutting. This helps the clay to stick when you remove the cutter. Or water on your cutter also works well. Ceramic tiles are great to use, cut your slab directly on the tile, then pop straight into your oven. Clean with baby wipes or cold water with dish liquid. I recommend to always clean cutters each time you use new colours to avoid colour transfer. Clean immediately after cutting acrylic paint with silkscreens. Do not put in the dishwasher. Keep away for heat, do not bake cutters in the oven.
