The Podracer AIO is a powerful whoop board designed in conjunction with Italian outfit, Zeez, to make the ultimate whoop AIO. This board is a designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact, and lightweight core for your build. The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and long-range cruiser like the TBS Aureo. Specifications: FC Side Mounting holes: 25.5×25.5 mm / M2 holes Up to 6S input 5V BEC up to 1.2A continuous STM32F411 MCU (Support BetaFlight, EmuFlight) MPU6000 Gyro/ACC OSD chip Onboard (AT7456E) 2 available UART LC Filter for 5V VTX and Camera Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano Support programmable LED like WS2812 etc Built-in current sensor ESC Side Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600 Input voltage: 2S-6S Lipo Continuous current: 30A Peak current: 35A ESC firmware: BLHELI 32 PWM Frequency Range: 24KHz up to 96KHz GPS Installation Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources. Note: The follow steps will disable LED and FC's SmartAudio and use as softserial for GPS. How To 1. Flash the board with Target: STM32F411 2. Download the Config file [HERE]. Then load it on the board. 3. Wire the GPS as shown Includes:1x TBS Podracer AIO >1x Capacitor1x AWG Cables Set with Shrink Tubes4x Mounting Gromets1x XT60 (Male)1x XT30 (Male)1x Pinheaders set for TBS VTX and RX
