This aftermarket mod adds a module bay to your Tango 2, enabling you to use the radio with other protocols than its native Crossfire. The module bay sticks to the back of the Tango 2 and plugs into the main control board. The bay is compatible with 'Lite' style modules, and only with Tango 2 mainboards V006H and newer. INSTALLATION INSTRUCTIONS Install the FPC cable to the PCB.With the blue side facing up, lift the lock and slide the cable in then lock it down. Feed the cable through the bottom and place the PCB to the module bay. Turn the module bay around to make sure everything fits accordingly. Close the case with the 2 screws provided. Use a dremel, knife or solder tip to cut a small hole according to the outline. Slide the flex PCB through the drilled case. Clean the back surface and tape the Tango 2 module bay down. Install the FPC cable into the receptacle. Close the Tango 2 case, and you're done! Note: TBS have discovered that XJT mini modules are using a pin that they did not anticipate for use in this module bay. It appears that the XJT mini module is the only module on the market that uses this pin. Due to this hardware incompatibility between the XJT mini module and the Tango 2 boards, the Tango 2 will NOT be able to support the XJT mini module.
