This item is a special order, please refer to our refund policy. Champions by design. 1:10 scale 2WD off road has been Team Associated’s signature class since the release of the RC10 in 1984. The Team Associated RC10 buggy series has won 13 of the 18 I.F.M.A.R. World Championships contested since the racing class began. In fact, Team Associated has won more 2WD I.F.M.A.R World Championships than all other manufacturers combined! In The Box (1) 1/10 2WD RC10B6 Builders Support Kit Needed to Complete RC10B6-based dirt oval or drag conversion kit Adjustable toe-in rear arms Conversion-specific body for dirt oval or drag application 1:10 scale electric motor and electronic speed control 7.4V-7.6V 2S LiPo with “shorty” battery dimensions (standard or low-profile height) 2-channel surface transmitter, 2-channel receiver, and steering servo Silicone shock fluid 1:10 scale wheels and tires (application specific) Parts Included Ball differential included Laydown and Layback transmission assemblies included for tuning mass balance to different track surfaces Adjustable differential height to allow drive shaft alignment through all ride height and axle height configurations V2 12mm Big Bore threaded aluminum shocks (four 24mm bodies and four 21mm shafts) with X-rings for low friction assembly V2 12mm shock springs (red front, yellow rear) for most dirt oval and on-road type applications RC10B6 front end assembly (steering, top plate, and suspension) with gull wing front arms and blue aluminum front axles Factory Team ball bearing set with 24 precision oiled ball bearings Set of six 48mm turnbuckles, ball cups, and HD metric ball studs Standard pivot rear aluminum arm mounts for use with 67mm CVA bones and RC10B6.1 rear hubs Aluminum rear ball stud mount with three link positions for maximum adjustability and added strength Lightweight aluminum one-piece top shaft New RC10B6.3 servo mounting system with direct-to-chassis aluminum chassis mounts and molded brace with transponder mounting location Octalock spur gears and 19mm Octalock LCF pads 2.5 mm thick machined shock pistons Blue aluminum shock bushings Molded wire clips included for motor and ESC wire organization +1 carbon fiber steering arms Black steel LP serrated wheel nuts 3mm I.D. molded plastic spacers included for ball stud and shim needs 7mm aluminum clamping wheel hexes Fasteners and metric hardware
