Timpano 400 Watts Car Audio Bass Amplifier TPT-BASS400 2 Ohm – 12 volts Monoblock Class D Car Amp Anybody in need of a car audio bass amplifier that can fit just about anyplace in their car and won’t break the bank should consider this Timpano Bass Series car amplifier. POWER: This monoblock Car Audio amplifier is designed to run a single dual 4 Ohm subwoofer powering up to 400 Watts of pure RMS power. Its high efficiency provides more power with less battery consumption. FEATURES: Heavy duty power and speakers terminals. Built-in variable crossover filters for easy tuning! Set setting for your subwoofer with a SUBSONIC ( HPF) filter 5 to 35Hz and LPF 35 to 250Hz without a need for an external crossover or DSP. Fine tune it according to your box with variable frequency dial and BASS BOOST at choose frequency up to +15 dB. Level controls to adjust the amount of signal that is coming into the amplifier from your signal source. DESIGN: Digital full bridge class D Brazilian technology allows this car audio amplifier to have a small footprint by integrating a high-speed mosfet power supply with top of line transistors to ensure performance in a small heat sink without compromising performance. Dimensions: 3.93″ depth x 5.02″ width x 2.00″ height HIGH LEVEL INPUTS with SIGNAL AUTO TURN ON: Attaches directly to systems using speaker-level inputs with signal auto turn-on to eliminate remote turn-on wiring The BASS Series from Timpano combines half-bridge amplifier engineering with the newest semiconductor technologies. Utilizing them, higher power-to-footprint ratios are possible, and the more compact chassis created for this technology does not degrade the output power or stability. To handle even the most demanding bass sessions, this amplifier comes with sturdy heatsink, heavy duty power and ground inputs, high current PCBs, and premium internal components. Additional Information: Number of Channels: 1400 Watts RMS Power at 2 Ohm 14.4Volts210 Watts RMS Power at 4 Ohm 14.4 VoltsSupply Voltage: 9V ~ 15VFrequency Response: 5Hz ~ 250HzCrossover Low Pass Filter: 35Hz ~ 250HzCrossover (HPF) Subsonic Filter: 5Hz ~ 35HzBass Boost Freq: 35Hz ~ 60HzBass Boost Gain: 0 dB ~ +15 dBInput Impedance: RCA 10k Ohm / Wire 1K OhmSignal to Noise: > 90 dBImpedance Output: 2 OhmMusical Consumption: 17ABass Consumption: 43ADimensions (L x W x H): 3.93” x 5.02” x 2.00”Weight: 1.11 Lbs Before Installing: You must follow the instructions for the product’s installation and connections to guarantee optimal performance. If you have any questions, get in touch with us. Before using the amplifier, always follow these guidelines:• Make sure the amplifier is switched off before adding or removing any connections. This prevents possible damage to the equipment connected to the amplifier;• Keep all cables as far away as possible from the ignition cables, electronic injection modules and starter switch since they may cause noise interference;• Always use 100% Copper cables and good quality connectors. This guarantees the sound’s quality and fidelity;• To avoid damaging the cables, make sure that they do not touch sharp metal edges. Important: Use a 40A fuse 12 inches away from the battery as a safety precaution The power rating data is based on equipment from the PRV Audio Group laboratory. Rated power tested with 40Hz sinusoidal signal and THD
