Options! Imagine being able to quickly and easily grab your wall-mounted table…and move it outside so you dont miss any of the campfire action while cooking! Unlike the benches, which are captured in their wall-mount brackets, the table just pops off its hanger then drops into the lower slots for interior use. Pull the table off the wall, locate the exterior latch pin stored on the inside of the table, thread it into the outside of the table and drop it in the keyed slot bracket mounted to the outside of your trailer. Exterior Key-slot bracket can be glued to trailer’s exterior with attached 3M adhesive tape and/or screwed in place(into a wall stud ONLY!) with included hardware. These brackets will be sold separately for multiple, unlimited locations both inside and outside of your trailer! Table dimensions are 38x18, sit 32” high and weigh 17lbs. To install: Inside trailer, measure up off the floor 32.5” and mark the wall on the studs(I use blue tape to avoid marking the wall"), align the lower screw holes here. Predrill with 1/8” bit, attach to wall studs. Exterior mount: Keeping table width in mind, set up and position the trailer as you would have it the majority of the time you’ll be using it. Clean the trailer with soap and then alcohol. Measure off the ground 32”. Mark the location, peel off the backing tape and position the BOTTOM OF THE CENTER SLOT over the mark(see picture below). Allow 24 hours to fully set. If youre planning to put more thean 20-30 pounds on the table, use the tape in conjunction with the screws into a wall stud.
Related
Related
Related
Related