Maple Leaf EH! Heat TransferDesigned by me and printed in Canada! Iron them onto all kinds of things! Comes in different sizes to suit the application you have in mind. :) Sizes are listed as Width x Height and are rounded up to the nearest 1/4" How to apply them:Press the fabric to remove moisture if necessary, for 5 seconds.You have two options- Hot Peel:Temperature: 300oF (approx 149oC) / warm or wool setting on your ironTime: Press for 15 secondsPressure: FirmPress, don't slide! Keep your iron in one place while fusing.Peel the film off as soon as you're done pressing. Be careful when peeling to make sure the entire design has released from the transfer sheet. If it is still on the transfer sheet, press the design for another 5 seconds.Once peeled, you can press the design for an additional 5 seconds to increase its durability. Use a Teflon Sheet or parchment paper to protect the design and your material! Cold Peel: (This is my preferred method so I don't burn my fingertips!)Temperature: 300oF (approx 149oC) / warm or wool setting on your ironTime: Press for 10 secondsPressure: Medium/FirmPress, don't slide! Keep your iron in one place while fusing.Remove your project from the heat and lay flat to cool. Once it is cool to the touch, gently peel the transfer sheet from the design. If it is still on the transfer sheet, press the design for another 5 seconds.Once peeled, you can press the design for an additional 5 seconds to increase its durability. Use a Teflon Sheet or parchment paper to protect the design and your material! These come packed with a small piece of parchment paper behind the design, to protect it from being scratched. If you are going to press the design for an additional 5 seconds after peeling, you can use that piece of parchment paper on top of the design to protect it from direct contact with your iron/press (unless your material melts from heat, in which case, you will need a large protective Teflon sheet or parchment paper to protect your whole project).Application instructions also come with each transfer, so you don't need to come back here when you're ready to apply it.Storage Tips:- Don't bend the transfer. The crease may become permanently visible when applied to your project.- Be careful not to touch or scratch the back side of the transfer. It will damage the ink of the design.- If you are going to be storing your transfers for a long time, remove them from the bag, or open the bag to let air flow in. Trapped humidity inside the bag could damage the ink of the design.
