20GA / 0.8mm - 2.5mm Base 18GA / 1mm - 2.5mm Base 16GA / 1.2mm - 4mm Base Manufactured out of Implant Grade Titanium (Ti-6AL-4V-ELI ASTM F136) Threadless Jewelry Method: Threadless jewelry is tensioned by using the end of the attachment and bending it within the bar to hold into place. To create the tension insert the pin on the end of the attachment slightly into the bar and bend slightly. Once inserted into the bar the bend in the pin should create the tension needed to hold into place. Direction below: Insert the pin on the end of the attachment 1/4 - 1/3 into the bar. (Labret, barbell etc.) Slightly bend the insertion pin within the bar. Push the end into the shaft and test the fit. Insuring the fit: Insure the attachment is held in place and is tight. Adjust as necessary, if the pin does not hold tight enough redo the steps & create more tension.
