Model: The cars have frames constructed of die-cast metal. The motor car has a motor with a flywheel. Both axles on the motor car powered. The cars have a digital decoder for DCC and conventional operation. There is a sound generator with extensive sound functions. Maintenance-free LEDs are used for the headlights, marker lights, and interior lighting. They work in conventional operation and they can be controlled digitally. There are special operating couplers between the cars. The motor car can also be used by itselfor Reproduction non-working prototype couplers for installation on the ends of the train are included. Total length over the buffers 175 mm / 6-7/8". Prototype: German Federal Railroad (DB) combustion powered rail car (VT), road number 98 9719, with control car (VS), road number 98 004. Dual motor design, built starting in 1955. Used in commuter service (branch lines). The cars look as they did around 1965. Unforgettable Branch Line Growlers. The experiences with the single-motor class VT 95 (later the class 795) rail busses developed by the firm Waggonfabrik Uerdingen proved the basic suitability of these units for the urgently necessary modernization of branch line service. At the same time, the class VT 95's power plant was too weak for routes with grades, particularly when operated with trailer units. For that reason, three prototypes of the class VT 98.9 (later the class 798.9) rail bus equipped with two 150 horsepower / 110 kilowatt Büssing motors followed a year later. These units fulfilled to a large extent the expectations set for them. However, the three test units still had Scharfenberg center couplers and lightweight spring-loaded metal straps for protection against contact with locomotives and cars with regular buffers.Delivery of the regular production two-motor class 98.95 (later the class 798.5) rail busses began in 1955. Compared to the test prototypes, the 329 units built were equipped with newly developed frames for the wheel sets with improved running characteristics as well as standard prototype couplers, regular buffers, and a standard design brake system. This enabled these more powerfully motorized rail cars to also pull transfer freight cars if necessary. In addition, the VT 98 units had a form of multiple unit control that enabled not only shuttle operation, but also the control of a motor car at the other end of the train. Suitable control cars (VS 98) and trailer cars (VM 98) were also placed into service to go with these powered rail cars. These crimson rail bus sets quickly defined the look on German branch line routes, where they quickly replaced the trains that previously were still hauled by steam locomotives. The Uerdingen rail bus sets left an enduring impression on the memory of many railroad passengers: For decades, these red growlers were synonymous for mobility in rural areas. The hearts of many railroad users still belong to these lovable "branch line saviors" from the time when they were placed into service. Open view through the cars. Sound generator with extensive sound functions. Continuous lighting with LEDs. DCC SX2 SX MFX Headlight(s) X X Horn X X Diesel locomotive op. sounds X X Interior lights X X Direct control X X Sound of squealing brakes off X X Rear Headlights off X X Bell X X Front Headlights off X X Station Announcements X X Letting off Air X X Conductor's Whistle X X Doors Closing X X Toilet being flushed X X Light Function X X Special sound function X X Replenishing fuel X X
