Hiwonder TTL/USB Serial Bus Servo Debugging Board The Hiwonder TTL/USB Servo Debugging Board is a compact interface for connecting one compatible Hiwonder serial bus servo to PC software or a microcontroller. Use it to inspect and adjust servo parameters, read a servo angle and send serial control commands while developing, testing or servicing a serial bus servo project. What It Helps You Do Adjust compatible servo parameters: connect to supported PC software for setup and debugging. Read servo angle: check the reported angle of a connected compatible serial bus servo. Connect through USB: use the USB port for a PC-based debugging workflow. Integrate through TTL serial: connect TXD and RXD with a compatible microcontroller for embedded servo control. Keep the hardware compact: the official board diagram specifies a 25 × 40mm board size. Interface Overview The board provides a USB port, a serial port, a serial bus servo connection and battery positive/negative terminals. The interface graphic also identifies the signal, servo-anode and servo-cathode connections. Follow the polarity markings and the wiring requirements of the actual connected servo and power source. PC and Microcontroller Workflows For PC work, connect the board by USB and use the compatible Hiwonder software to check or adjust the connected servo. For embedded projects, use the serial connection with a compatible controller's TXD and RXD pins to communicate with the servo through the debugging board. This makes the board useful both as a setup tool and as a bridge during microcontroller development. Compatibility Notes This board is intended for a compatible Hiwonder serial bus servo, not a general-purpose three-wire PWM servo tester. The official product guidance specifies one servo connection per board. Confirm the servo model, connector orientation, communication protocol and power requirements before applying power. Use a regulated supply appropriate for the connected servo and do not reverse the battery terminals. Specifications Product type TTL/USB serial bus servo debugging interface Compatible application One compatible Hiwonder serial bus servo PC connection USB Microcontroller connection TTL serial via TXD and RXD Primary functions Parameter adjustment and servo-angle reading Board size 25 × 40mm FAQ Can this board test several servos at once? No. The official product guidance specifies one compatible serial bus servo connection per debugging board. Can I use it with a standard PWM hobby servo? No. This is a TTL/USB interface for compatible Hiwonder serial bus servos. Verify that the servo uses the required serial bus communication method before connecting it. What can I do with the PC connection? You can use compatible PC software to adjust supported servo parameters and read the angle of the connected servo. Can I use it in an Arduino or other microcontroller project? Yes, the board provides a serial connection for TXD and RXD communication with a compatible microcontroller. Configure the host and servo according to the applicable communication requirements. Are the servo, USB cable and power supply included? The official product page does not provide a packing list. Treat the board, servo, cable and power source as separate items unless the order details explicitly state otherwise.
Related
Related
Related
Related