Description The Unity Tracks single-phase track end cap is a white plastic finishing component designed to seal open ends on Maytoni Unity single-phase track lighting systems. Measuring 6cm wide by 3.7cm long by 2cm tall, the cap clips onto the track profile to close off the conductive rail, preventing dust ingress and accidental contact with live components. Used in retail, office and residential track lighting installations where the track terminates against a wall, in a corner, or at a defined end point rather than continuing through to another section. The end cap provides a clean visual finish and meets safety requirements by isolating the track's internal rail from exposure. Installation requires no tools — the cap pushes onto the track end until it seats against the internal stops. The white finish matches the Unity Tracks white rail system, creating a continuous appearance where the track meets the ceiling or wall. The plastic construction is lightweight and durable enough for typical indoor use, with no maintenance required once fitted. Maytoni includes a 2-year warranty covering manufacturing defects. Specification Height 2cm Length 3.7cm Width 6cm Finish White Construction Plastic Warranty 2 Year Guarantee Downloads Product Manual Frequently Asked Which track systems is this end cap compatible with? This end cap is designed specifically for Maytoni Unity Tracks single-phase track lighting systems in white. It will not fit three-phase tracks or track systems from other manufacturers due to differences in rail profile dimensions. How is the end cap fitted? The end cap pushes onto the open end of the track rail until it seats against the internal stops. No screws or tools are needed. Ensure power is isolated before fitting to avoid contact with live components inside the track. Can this be used outdoors? No. The Unity Tracks system and this end cap are designed for indoor use only. The plastic construction and lack of weatherproofing make it unsuitable for outdoor or high-moisture environments. How many end caps are needed per installation? One end cap is needed for each open track end. A straight run of track terminating at both ends requires two end caps. Track runs that connect to corner joiners or continuous sections do not need end caps at those junctions.
