If you're doing a custom K swap project and need a super clean and high-quality wiring harness solution that features a drive by wire throttle body, this is for you. Straight from our Universal RWD DBW Electronics Package, this engine harness is designed to pair your K24A engine with a Haltech S2 ECU, along with a drive-by-wire throttle body and pedal of your choice. If you are looking to simply your chassis integration even more, consider our KPower Fuse Box kit that easily connects to this harness. Best of all, this fully terminated harness includes three connectors with terminals so you can easily crimp the mating end of the connectors to your cabin harness, throttle pedal, and more. If you're wiring a race car, pair this harness with some of the existing relays in your car, or use a standalone universal fusebox or PDM to complete your setup. For installation, attach the engine harness to your engine, mount the fuse box to the chassis, and connect the fuse box ring terminal to a 12V power source. Then, connect the C101 connectors from the engine and fuse box, and run new wires from the 2- and 3-pin connectors to your starter, fuel pump, and radiator fan. You'll need to manually wire in your vehicle speed sensor utilizing the included terminal pins. It’s that simple! The wiring diagram and FREE Haltech basemap can be downloaded for his package on our Installation and Basemaps page. This harness features: 100% plug-and-play design that attaches directly to the Haltech S2 A and C connectors OEM C101 cabin harness connector with the female side included DTM 6-pin connector to splice in any drive-by-wire pedal of your choice A Bosch 74mm drive-by-wire throttle body connector All new OEM K series connectors A fuel injector sub-harness that makes changing to different fuel injectors easy Teflon-coated high temperature wire Raychem DR-25 heat shrink loom Flex fuel input to easily add an ethanol sensor Pre-wired for Bosch oil pressure and temperature sensor At this time we are not offering any modifications to this harness, and there is no cable throttle body option. Notes: All products are designed for off-road motorsports use only. Users are responsible for complying with all local laws in their county, state, and country. Note that our engine wiring harness is designed for 2004-2008 K24A sensors, including the crank sensor, knock sensor, and injectors. This harness is not pinned for OEM CANBUS programming, however if Haltech has your CANBUS protocol setup, you can add the CAN high and CAN low signal wires to enable that feature. KPower Recommended Product for a Universal DBW build: KPower DBW Intake and Fueling Bundle Pack KPower Universal Fuse Box Kit Haltech S2 ECU Haltech Wideband O2 Sensor Kit Bosch Combo Oil temperature/Oil Pressure Sensor Haltech Can Gauge, iC-7, or uC-10 Dash Display KPower Flex Fuel Kit
